Remote Node Filter; Figure 4-4 Menu 11.5 - Remote Node Filter (Rfc 1483 Or Enet Encap Encapsulation ) - ZyXEL Communications Prestige 650H-17 User Manual

Prestige 650H-17 ADSL Router
FIELD
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1, RIP-2B or RIP-2M.
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
Multicast
None disables IGMP.
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their
numbers separated by commas. Configure the filter sets in menu 25
first (see the IP Policy Routing chapter) and then apply them here.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.3

Remote Node Filter

Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER] to display Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and also to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. The Prestige has a prepackaged filter set, NetBIOS_WAN, that
blocks NetBIOS packets (call protocol filter = 1). Include this in the call filter sets if you want to prevent
NetBIOS packets from triggering calls to a remote node.
Figure 4-4 Menu 11.5 – Remote Node Filter (RFC 1483 or ENET ENCAP Encapsulation )
4-8
Table 4-2 Remote Node Network Layer Options
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 12, 11
Output Filter Sets:
protocol filters=
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTITON
device filters=
device filters=
EXAMPLE
RIP-1
None
3, 4, 5, 6
Remote Node Configuration