Jumper Settings
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
JP-CMOS Clear Jumper
JP1
1-2* Normal*
2-3
CMOS Clear
JP-P/S Port 5V Standby Power Selection(Optional)
JP2
1-2* 5V standby power input*
2-3
5V power input
Close Open * = Default setting.
If you want to clear the system configuration,use the JP1(Clear CMOS Jumper) to clear date
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen
even if the frequency multiplier setting in CMOS setup is changed.
Selection
Selection
Hardware Installation
9