Jumper Settings - Zotac INTEL Series User Manual

Jumper Settings

This section explains how to configure the motherboard's hardware. Before using
your computer, make sure all jumpers and DRAM modules are set correctly. Refer to
this section whenever in doubt.
CMOS Clear Jumper-JP1
JP1
1-2* Normal*
1
2-3 CMOS Clear
1
Close Open
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) to clear data.
USB Voltage Selection Jumper (Optional)-JP3/4
JP3/4 Selection
1-2 5V VCC
1
1
2-3* 5V DUAL*
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen
even if the frequency multiplier setting in CMOS setup is changed.
Selection
* = Default setting.
Hardware Installation
17