Jumper Settings - Zotac Supreme D2700ITX series User Manual

Jumper Settings

This section explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this section
whenever in doubt.
CMOS Clear Jumper-JP1
JP1
1-2* Normal*
1
2-3 CMOS Clear
1
Close Open
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) or SW1 (Clear CMOS Button) to
clear data.
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen even if the
frequency multiplier setting in CMOS setup is changed.
mSATA / SATA Selection Jumper-JP3
JP3
2-3* use SATA2 port*
1
1-2 use mSATA port
1
Note: The mSATA port can not be used with the SATA2 port at the same time.
Selection
* = Default setting.
Selection
Hardware Installation
21