Jumper Settings - Zotac nForce 610i-ITX User Manual

Hide thumbs Also See for nForce 610i-ITX:
Table of Contents

Advertisement

NForce 610i/630i-ITX series Motherboard
Jumper Setting
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
JP-CMOS Clear
JP
1-2*
2-3
JP - P/S Port 5V Standby Power Selection
JP
1-2*
2-3
Close Open * = Default setting.
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) to clear data.
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be
seen even if the frequency multiplier setting in CMOS setup is changed.

Selection
Normal*
CMOS Clear
Selection
5V standby power input*
5V power input
Hardware Installation

Advertisement

Table of Contents
loading

Table of Contents