Expansion Slots; Jumper Settings - Zotac Z68ITX series User Manual

Intel Z68-ITX series Motherboard

Expansion Slots

The motherboard contains two expansion slots, one Mini PCIe slot and one PCIe x16 slot.
Mini PCIe Slot-Mini_PCIE1
There is one Mini PCIe slot, switchable for Mini PCIe and mSATA interface.
(Remove the WiFi module first before installing the mSATA SSD into the slot. Please refer to
page 13-14.)
PCIe x16 Slot-PCIE1
There is one PCIe x16 slot reserved for graphics card. It is fully compliant with PCIE 2.0
specification.

Jumper Settings

This section explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this section
whenever in doubt.
CMOS Clear Jumper-JP1
JP1
1-2* Normal*
1
2-3 CMOS Clear
1
Close Open
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) to clear data.
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen even if the
frequency multiplier setting in CMOS setup is changed.
20
+
115XLM
REMOVE
Selection
* = Default setting.
240 120 240 120
121 121
Switch Jumper for WiFi/mSATA-JP4
JP4
1-2* WiFi*
1
2-3
1
Mini_PCIE
PCIE1
Selection
mSATA