Jumper Settings - Zotac Intel NM70-ITX Series User Manual

Intel NM70-ITX series Motherboard

Jumper Settings

This section explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this section
whenever in doubt.
CMOS Clear Jumper-JP1
JP1
1-2* Normal*
1
2-3 CMOS Clear
1
Keyboard Power Selection for Wakeup-JP2
JP2
1-2 Power off in S3/S4/S5
1
2-3* Power on in any state*
1
Case Open Jumper-JP5
JP5 Selection
Open Case close
Short Case open
Close Open
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) to clear data.
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen even if the
frequency multiplier setting in CMOS setup is changed.
16
Selection
Selection
* = Default setting.