Playing An Audio Cd - Zoom SIB-01 Installation Manual

• If you press the [EXIT] key instead of the [ENTER] key, the
display returns to the condition of the previous step.
• The fastest writing speed supported by the connected
CD-R/CD-RW drive will automatically be selected.
10.
When writing is complete, press the [EXIT] key.
The system returns to the condition of step 5. To add more audio data, select
the project with the desired source data and then repeat the above steps.
• When a new track is added, a pause of 2 seconds is created
NOTE
automatically.
• As long as the CD-R/CD-RW disc has not been finalized, the
disc cannot be played on an ordinary CD player. (For information
on how to audition a non-finalized CD-R/CD-RW disc, refer to
the next section.)
11.
To terminate the write process and return to the main screen,
press the [EXIT] key several times.

Playing an Audio CD

To play an audio CD inserted in the CD-R/CD-RW drive, proceed as
follows. This method can also be used to audition a CD-R/CD-RW disc to
which audio data were written.
A non-finalized CD-R/CD-RW disc cannot be played by any other
method.
1.
Verify that the CD-R/CD-RW drive is properly connected to the
MRS-1044 and that a suitable disc is inserted.
2.
In the main screen, press the [PROJECT/UTILITY] key.
Use the cursor [ E ]/[ R ] keys to make the display indicate
3.
"UTILITY CD-R/RW", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE properly recognized the CD-R/CD-RW drive. Check the power
on/off condition of the drive and the SCSI connection.
14 ZOOM MRS-1044 ver 1.2
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"CD-R/RW PLAYER", and then press the [ENTER] key.
The display indicates the following information.
( 1 ) ( 2 ) ( 3 )
( 4 )
(1)Track number
Indicates the number of the track on the audio CD or CD-R/CD-RW
disc.
(2)Playback method
Indicates the currently selected audio CD playback method. "D" stands
for digital playback and "A" for analog playback.
(3)Finalize status
When a "*" symbol is shown here, a non-finalized CD-R/CD-RW disc
is inserted.
(4)Current location
The location in the current track is shown here in hours (H), minutes
(M), and seconds (S).
Use the FF [ Y ] key and REW [ T ] key to select the track to be
5.
played.
While the above indication is shown, the FF [
can be used to select the track on the CD. The FF [
T
next track and the REW [ ] key selects the previous track.
Use the cursor [ Q ]/[ W ] keys to select the playback method.
6.
Q
Each push of the cursor [ ]/[
two methods.
G
D (Digital playback)
The digital audio signal of the CD is read into the MRS-1044 and
Y T
] and REW [ ] keys
Y
] key selects the
W
] keys toggles between the following
ZOOM MRS-1044 ver 1.2 15