Table of Contents
Advertisement
Reading a Stored Project from
External Media (Project Restore)
You can read any project that was stored on an external SCSI device back
into the hard disk of the MRS-1044.
The screens and operation steps are slightly different, depending on which
kind of drive is used as restore source.
I Restoring from a CD-R/CD-RW drive
1.
Verify that the CD-R/CD-RW drive is properly connected to the
MRS-1044.
2.
In the main screen, press the [PROJECT/UTILITY] key.
3.
Use the cursor [<]/[>] keys to make the display indicate
"UTILITY BACKUP", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE
properly recognized the CD-R/CD-RW drive. Check the power
on/off condition of the drive and the SCSI connection.
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"BACKUP LOAD", and then press the [ENTER] key.
The indication "LOAD InsDisc1" appears on the display.
If a CD-R/CD-RW drive and another SCSI device are connected at the
same time, a screen for selecting the restore source appears after
pressing the [ENTER] key in step 4.
E
R
Use the cursor [
]/[
] keys to select "CD-R/RW".
5.
Insert the CD-R/CD-RW disc (disc number 1) with the stored
project into the drive, and press the [ENTER] key.
The name of the project to be restored and the new project number are
26
ZOOM MRS-1044 ver 1.2
shown on the display.
25
Project name
Project number
When restoring a project, the MRS-1044 automatically allocates a
new project number. This prevents accidentally deleting or
overwriting an existing project on the hard disk, even if it has the
same name.
• If the backup spans several volumes, make sure that the first
NOTE
disc inserted is the disc number 1. If the disc number is different,
correct restore will not be possible.
• To change the restore source disc, press the [EXIT] key and
repeat the procedure from step 4.
6.
If you wish to check the restore source directory, press the
cursor [ W ] key.
The display indication changes to the directory name. Pressing the
Q
cursor [
] key returns to the previous display.
25
Directory name
7.
Press the [ENTER] key.
The indication "LOAD SURE?" appears on the display, to verify the
restore process.
8.
To execute the restore process, press the [ENTER] key. If you
wish to cancel the process, press the [EXIT] key instead.
When restore starts, the indication "LOAD wait..." appears on the
display.
When the project backup spans several CD-R/CD-RW discs, a
ZOOM MRS-1044 ver 1.2
27
Advertisement
Table of Contents
