Table of Contents
Advertisement
Creating an Audio CD
This section describes how you can write V-takes recorded on the
MRS-1044 onto a disc in a CD-R/CD-RW drive connected to the
MRS-1044, to create an audio CD.
V-takes that can be written on an audio
CD
Only the V-takes 10 of tracks 9/10 can be used for writing to an audio CD.
Therefore it is necessary to first make sure that these V-takes contain the
desired material. This can be achieved in one the following ways.
G
Perform playback on an external DAT or MD recorder which
contains the project mixdown, and record it on V-takes 10 of
tracks 9/10
G
Bounce the entire project onto the V-takes corresponding to
V-takes 10 of tracks 9/10
V-take
1
2
3
4
5
6
7
8
9
10
Track
1
2
3 4 5 6 7/8 9/10
Only one project can be written at a time. However, as long as the
CD-R/CD-RW disc has not been finalized, it is possible to call up another
project and add audio data.
10
ZOOM MRS-1044 ver 1.2
Bounce
(Provided there is room on the media, up to 99 songs can be recorded.)
• For information on how to use the bounce function, refer to the
instruction manual of the MRS-1044 (p. 37).
• "Finalizing" an audio CD refers to the procedure of making it playable
on an ordinary CD player. After it has been finalized, no more data can
be added to a CD-R/CD-RW disc.
• The waveform data of V-takes 10 of tracks 9/10 are recorded as is on
the audio CD. Note that fader, EQ, effects, and panning have no effect
NOTE
on the recorded data.
• It is not possible to specify just a portion of a V-take for recording. If
necessary, use the trimming function (p. 35) to cut unneeded sections
before and after the desired portion.
About CD-R/CD-RW discs
When a CD-R/CD-RW drive is connected to the MRS-1044 for creating an
audio CD, you can select either CD-R or CD-RW discs as media. The
features of the two disc types are described below.
G
CD-R
This media type allows only one-time recording or adding of data. Once
data have been written, they cannot be changed or erased. CD-R discs
are available in 650 MB and 700 MB capacities.
To newly write a V-take of the MRS-1044 to disc, a blank CD-R is
required. As long as the disc has not been finalized, it is possible to add
further audio data up to the maximum capacity of the disc.
G
CD-RW
This media type allows recording, adding, and bulk-erasing of data.
CD-RW discs are also available in 650 MB and 700 MB capacities.
To newly write a V-take of the MRS-1044 to disc, a blank or
completely erased CD-RW is required. (For information on how to
erase a CD-RW, refer to page 18.) As long as the disc has not been
finalized, it is possible to add audio data up to the maximum capacity of
the disc.
ZOOM MRS-1044 ver 1.2
11
Advertisement
Table of Contents
