Recording A V-Take On A Cd-R/Cd-Rw Disc - Zoom SIB-01 Installation Manual

Recording a V-take on a CD-R/CD-RW
Disc
V-takes 10 of tracks 9/10 in the currently selected project can be written to
a CD-R/CD-RW disc, to create an audio CD.
1.
Verify that the CD-R/CD-RW drive is properly connected to the
MRS-1044 and that a suitable disc is inserted.
To newly write audio data, use a blank CD-R/CD-RW or a completely
erased CD-RW.
To add audio data, use a CD-R/CD-RW which has not been finalized.
2.
Select the project on the MRS-1044 that is to be used as write
source.
Verify that V-takes 10 of tracks 9/10 contain the stereo data to be
written as audio data to the disc. If necessary, use the trimming
function (p. 35) to cut unneeded sections before and after the desired
portion of the V-take.
3.
In the main screen, press the [PROJECT/UTILITY] key.
The display will indicate "PROJECT".
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"UTILITY CD-R/RW", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE properly recognized the CD-R/CD-RW drive. Check the power
on/off condition of the drive and the SCSI connection.
Use the cursor [ E ]/[ R ] keys to make the display indicate
5.
"CD-R/RW BURN CD", and then press the [ENTER] key.
The duration of the source V-takes is shown at the bottom of the
display in hours (H), minutes (M), seconds (S), and milliseconds
(MS).
12 ZOOM MRS-1044 ver 1.2
6.
To check the remaining write capacity of the disc, press the
cursor [ W ] key.
The indication at the bottom of the display changes to show the
remaining capacity of the disc. Pressing the cursor [
the previous display.
To audition the source V-takes, press the PLAY [ R ] key. To
7.
stop playback, press the STOP [ P ] key.
8.
Press the [ENTER] key twice.
The display indication changes as follows.
Number of track on disc to be written
9.
To carry out the write process, press the [ENTER] key.
Writing to the CD-R/CD-RW disc begins. During the write process,
the indication "wait..." is shown on the display. On the lower part of
the display, you can check the progress of the write operation.
When the write process is finished, the display indication changes to
"COMPLETE".
Q
] key returns to
ZOOM MRS-1044 ver 1.2 13