Finalizing A Cd-R/Cd-Rw Disc - Zoom SIB-01 Installation Manual

becomes available at the rear panel [OUTPUT] jacks (DIGITAL,
PHONES, MASTER L/R). (Default setting)
G
A (Analog playback)
The audio signal of the CD is reproduced via the headphone and line
outputs of the CD-R/CD-RW drive.
During audio CD playback, the fader, EQ, reverb, chorus, and
NOTE panning settings of the MRS-1044 have no effect. However, when
"D" is selected, the MASTER fader can be used to adjust the CD
volume.
7.
To control CD playback/stop, use the transport section keys
of the MRS-1044.
While the above indication is shown, the transport section keys of the
MRS-1044 operate as follows.
G PLAY [ R ] key
Playback of the selected track starts. Pressing the key during analog
playback sets the system to pause mode.
G STOP [ P ] key
Playback stops, and the system returns to the beginning of the current
track.
G FF [ Y ] key
Playback stops, and the system jumps to the beginning of the next track.
G REW [ T ] key
Playback stops, and the system jumps to the beginning of the previous
track.
During audio CD playback, the playback method (digital/analog)
NOTE cannot be switched. If one of the cursor [W]/[Q] keys is pressed,
only the indication "STOP PLAYER" is shown and the key press is
ignored.
8.
To return to the main screen, press the [EXIT] key several
times.
16 ZOOM MRS-1044 ver 1.2

Finalizing a CD-R/CD-RW Disc

"Finalizing" a CD-R/CD-RW to which audio data were written refers to the
procedure of making it playable on an ordinary CD player.
After a CD-R/CD-RW disc has been finalized, no more tracks can be
NOTE
added to it. Perform the following operation with care.
1.
Verify that the CD-R/CD-RW drive is properly connected to the
MRS-1044 and that a suitable disc is inserted.
2.
In the main screen, press the [PROJECT/UTILITY] key.
Use the cursor [ E ]/[ R ] keys to make the display indicate
3.
"UTILITY CD-R/RW", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE
properly recognized the CD-R/CD-RW drive. Check the power
on/off condition of the drive and the SCSI connection.
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"CD-R/RW FINALIZE", and then press the [ENTER] key.
The display indicates the following information.
( 1 )
( 2 )
(1)Total tracks
Indicates the total number of tracks on the CD-R/CD-RW disc.
(2)Play time
Indicates the total playing time of all tracks on the CD-R/CD-RW disc
(including pauses) in hours (H), minutes (M), and seconds (S).
ZOOM MRS-1044 ver 1.2 17