Table of Contents
Advertisement
6.
Turn the dial to select a restore source project, and press the
[ENTER] key.
The indication "LOAD SURE?" appears on the display, to verify the
restore process.
7.
To execute the restore process, press the [ENTER] key. If you
wish to cancel the process, press the [EXIT] key instead.
When restore starts, the indication "LOAD wait..." appears on the
display.
When the project backup spans several ZIP or MO discs, a message
prompting the user to insert the next disc appears after data from the
first disc have been read.
8.
When the above message appears, insert the next ZIP or MO
disc, and press the [ENTER] key.
The restore operation resumes. The new disc number and the
indication "wait..." appear on the display.
To cancel the operation, press the [EXIT] key to bring up the
indication "CANCEL?" on the screen, and then press the ENTER key.
When a backup spans several media volumes, be sure to insert
NOTE
the discs in the same order as during backup. Otherwise correct
restore is not possible.
9.
Repeat the above steps until the entire project is restored.
When the restore operation is finished, the display indication changes
to "LOAD COMPLETE".
10.
To return to the main screen, press the [EXIT] key several
30
ZOOM MRS-1044 ver 1.2
times.
I Restoring from a hard disk
1.
Verify that the hard disk is properly connected to the
MRS-1044.
2.
In the main screen, press the [PROJECT/UTILITY] key.
Use the cursor [ E ]/[ R ] keys to make the display indicate
3.
"UTILITY BACKUP", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE
properly recognized the hard disk. Check the power on/off
condition of the hard disk and the SCSI connection.
4.
Use the cursor [ E ]/[ R ] keys to make the display indicate
"BACKUP LOAD", and then press the [ENTER] key.
The name of the project to be restored and the new project number are
shown on the display. If you wish to check the restore source
W
directory, press the cursor [
25
5.
Turn the dial to select a restore source project, and press the
[ENTER] key.
The indication "LOAD SURE?" appears on the display, to verify the
restore process.
6.
To execute the restore process, press the [ENTER] key. If you
wish to cancel the process, press the [EXIT] key instead.
When restore starts, the indication "LOAD wait..." appears on the
display. When the restore operation is finished, the display indication
changes to "LOAD COMPLETE".
7.
To return to the main screen, press the [EXIT] key several
times.
] key.
ZOOM MRS-1044 ver 1.2
31
Advertisement
Table of Contents
