Table of Contents
Advertisement
message prompting the user to insert the next disc appears after data
from the first disc have been read.
9.
When the above message appears, insert the next CD-R/CD-
RW disc, and press the [ENTER] key.
The restore operation resumes. The new disc number and the
indication "wait..." appear on the display.
To cancel the operation, press the [EXIT] key to bring up the
indication "CANCEL?" on the screen, and then press the ENTER key.
When a backup spans several media volumes, be sure to insert
NOTE
the discs in the same order as during backup. Otherwise correct
restore is not possible.
10.
Repeat the above steps until the entire project is restored.
When the restore operation is finished, the display indication changes
to "LOAD COMPLETE".
11.
To return to the main screen, press the [EXIT] key several
times.
I Restoring from a ZIP or MO drive
1.
Verify that the ZIP or MO drive is properly connected to the
MRS-1044.
2.
In the main screen, press the [PROJECT/UTILITY] key.
3.
Use the cursor [ E ]/[ R ] keys to make the display indicate
28
ZOOM MRS-1044 ver 1.2
"UTILITY BACKUP", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE
properly recognized the ZIP or MO drive. Check the power on/off
condition of the drive and the SCSI connection.
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"BACKUP LOAD", and then press the [ENTER] key.
The indication "LOAD InsDisc1" appears on the display.
If a CD-R/CD-RW drive and another SCSI device are connected at the
same time, a screen for selecting the restore source appears after
pressing the [ENTER] key in step 4.
E
R
Use the cursor [
]/[
] keys to select "ExtDRV".
5.
Insert the ZIP or MO disc (disc number 1) with the stored
project into the drive, and press the [ENTER] key.
The name of the project to be restored and the new project number are
shown on the display.
If you wish to check the restore source directory, press the cursor [
key.
25
• If the backup spans several volumes, make sure that the first
NOTE
disc inserted is the disc number 1. If the disc number is different,
correct restore will not be possible.
• To change the restore source disc, press the [EXIT] key and
repeat the procedure from step 4.
W
]
ZOOM MRS-1044 ver 1.2
29
Advertisement
Table of Contents
