Table of Contents
Advertisement
Getting Connected
REMOTE IN
SERIAL NO.
REMOTE IN
DC INPUT
AC adapter
When using the 3000B with one bass
guitar amplifier, make the connection
with a mono cable. For driving two
bass guitar amplifiers, a stereo Y
cable is required. The use of two
amplifiers will result in impressive
wide sound for stereo effects.
Before Playing
After completing connection, the volume has to be adjusted according to the following procedure.
Cut the power to the amplifier, turn the volume down to its minimum level, and
1
STEP
connect the 3000B correctly to the musical instrument and amplifier
2
Power up the 3000B.
STEP
Connect the accessory AC adapter to the DC INPUT jack. The power to
the 3000B is ON when the AC adapter is plugged into a power outlet.
3
Switch ON the power to the amplifier.
STEP
Adjust the volume of the musical instrument and the amplifier while
playing the instrument.
ADVANCED BASS EFFECTS PROCESSOR
When using the optional remote
pedal RP01, use the remote
cable supplied with the RP01 to
connect the REMOTE OUT
jack of the RP01 to the
PEDAL SW
STATUS
MONITOR
PEDAL-WAH
ON/OFF(PEDAL SW)
PEDAL-PITCH
ON/OFF(PEDAL SW)
VOLUME
ASSIGN
REMOTE IN jack of the 3000B.
MODE DELECT
RTM MODE
MODE SELECT
DELAY MODE
(PEDAL SW TRIGGER)
Power for the remote pedal will
be supplied by the 3000B.
Other remote cables (RC05,
RC10) cannot be used.
RP01
DC9V
300mA
OUTPUT
Bas amplifiers
Bass
INPUT
OUTPUT
INPUT
(PHONES)
PHONES OUT
A pair of stereo headphones can
be connected to the OUTPUT
(PHONES) jack. If the volume
level from the headphones is low,
use phones with low impedance.
Headphones
3
Advertisement
Table of Contents
