Table of Contents
Advertisement
5.
Press the [ENTER] key.
The screen for specifying the V-take start point appears.
02
6.
Move the start point back as required, and press the [ENTER]
key.
The screen for specifying the V-take end point appears.
05
For details on how to specify the position, refer to page 39 of the
MRS-1044 operation manual.
7.
In the same way, move the end point forward as required, and
press the [ENTER] key.
By pressing the PLAY [
MRS-1044, you can play the range from the specified start point to the
specified end point.
The start point cannot be moved forward from the original position,
NOTE
and the end point cannot be moved backward from the original
position.
8.
When the end point has been specified, press the [ENTER]
key.
36
ZOOM MRS-1044 ver 1.2
R
] key in the transport section of the
The indication "TrTrim SURE?" appears on the display, to verify the
trimming process.
Also after the start point and end point have been specified, the
original audio data are still available until the [ENTER] key is
pressed in step 9. By pressing the [EXIT] key you can move back
through the steps one by one and make corrections if needed.
9.
To execute the trimming process, press the [ENTER] key. If
you wish to cancel the process, press the [EXIT] key instead.
When you press the [ENTER] key, data outside of the specified start
point to end point range are deleted.
When the trimming operation is finished, the display indication
changes to "COMPLETE".
New start point
Selected V-take
When the start point was moved back, the entire V-take is shifted
NOTE
to the front.
10.
To return to the main screen, press the [EXIT] key several
times.
New end point
ZOOM MRS-1044 ver 1.2
37
Advertisement
Table of Contents
