Storing A Project On External Media; Project Backup - Zoom SIB-01 Installation Manual

Storing a Project on External Media

(Project Backup)

You can store any project on an external SCSI device for backup. The
following types of SCSI devices can be used.
G
CD-R/CD-RW drive
G
MO (Magneto-optical disc) drive (128 MB, 230 MB, 540 MB)
G
ZIP drive (100 MB, 250 MB)
G
Hard disk
Depending on the type of media used for backup, you can have a large
project span several media volumes, or add backup data for a separate
project on one media volume. The following table shows the available
backup methods for various media.
Adding backup data
CD-R (*1)
CD-RW (*2)
MO (*3)
ZIP (*3)
Hard disk (*3)
*1
Only possible with blank disc
*2
Possible with blank disc or bulk erased disc
*3
Only possible with disc formatted in MRS-1044. (For information on
formatting media, refer to page 34.) Even if the media already contains
a MRS-1044 backup, you can add more if there is still capacity on the
disc.
For a list of compatible drive brands and models, please visit the ZOOM
Corporation web site (http://www.zoom.co.jp).
1.
Verify that the SCSI device is properly connected to the
MRS-1044 and that the drive is turned on.
2.
When using a CD-R/CD-RW drive, MO drive, or ZIP drive for
20 ZOOM SIB-01 ZOOM MRS-1044 ver 1.2
Backup/restore spanning
several volumes
No Yes
No Yes
Yes Yes
Yes Yes
Yes No
backup, make sure that a suitable disc is inserted.
3.
In the main screen, press the [PROJECT/UTILITY] key.
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"UTILITY BACKUP", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE
properly recognized the SCSI device. Check the power on/off
condition of the device and the SCSI connection.
5. Use the cursor [ E ]/[ R ] keys to make the display indicate
"BACKUP SAVE", and then press the [ENTER] key.
The screen for selecting the project for backup appears.
2
If a CD-R/CD-RW drive and another SCSI device are connected at the
same time, a screen for selecting the target device appears after
pressing the [ENTER] key in step 5.
E R
Use the cursor [ ]/[ ] keys to select "CD-R/RW" (when backing up
onto a CD-R/CD-RW drive) or "ExtDRV" (when backing up on
another SCSI device).
6.
Turn the dial to select a project, and press the [ENTER] key.
The required storage capacity for backing up that project is shown on
the display (in MB).
ZOOM MRS-1044 ver 1.2 21