Erasing A Cd-Rw Disc - Zoom SIB-01 Installation Manual

5.
Press the [ENTER] key.
The display now shows the indication "FINALIZ SURE?".
6.
To carry out the finalizing process, press the [ENTER] key
once more.
The finalizing process starts. During the operation, the display shows
"FINALIZ wait...".
When the finalizing process is finished, the display indication changes
to "FINALIZ COMPLETE".
The CD-R/CD-RW disc can now be played on an ordinary CD player.
However, no more tracks can be added to it.
By erasing the entire disc, a CD-RW disc can be used again also
after finalizing. Refer to the explanation in the next section.
7.
To return to the main screen, press the [EXIT] key several
times.

Erasing a CD-RW Disc

The entire information on a CD-RW disc (audio data or backup data) can be
erased, thereby returning the disc to the blank state.
1.
Verify that the CD-R/CD-RW drive is properly connected to the
MRS-1044 and that a suitable CD-RW disc is inserted.
2.
In the main screen, press the [PROJECT/UTILITY] key.
Use the cursor [ E ]/[ R ] keys to make the display indicate
3.
"UTILITY CD-R/RW", and then press the [ENTER] key.
If the above menu does not appear, the MRS-1044 has not
NOTE properly recognized the CD-R/CD-RW drive. Check the power
on/off condition of the drive and the SCSI connection.
18 ZOOM MRS-1044 ver 1.2
Use the cursor [ E ]/[ R ] keys to make the display indicate
4.
"CD-R/RW CDRW ERS", and then press the [ENTER] key.
The display indication changes to "CdrwErs NORMAL".
Use the cursor [ W ]/[ Q ] keys to select one of the following two
5.
CD-RW erase methods.
G
NORMAL (Default setting)
Information from all areas of the disc is erased. This operation takes
longer than the QUICK erase operation, but all contents of the disc are
reliably erased. This method is recommended. (Required time is max.
74 minutes for a 650 MB disc and 80 minutes for a 700 MB disc.)
G
QUICK
Only the track information on the CD-RW disc is erased. The operation
takes a few minutes.
6.
Press the [ENTER] key.
The display now shows the indication "CdrwErs SURE?".
7.
To carry out the erase process, press the [ENTER] key once
more.
The erase process starts. During the operation, the display shows
"CdrwErs wait...".
When the erasing process is finished, the display indication changes to
"CdrwErs COMPLETE".
8.
To return to the main screen, press the [EXIT] key several
times.
ZOOM MRS-1044 ver 1.2 ZOOM SIB-01 19