Fluke Data Acquisition System/Data Logging System 2680A Getting Started Manual page 6

DO NOT OPERATE IN EXPLOSIVE ATMOSPHERES
To avoid personal injury or death, do not remove the device cover without first
removing the power source connected to the rear panel. Do not operate the device
without the cover properly installed. There is no need for the operator to remove
the cover.
DO NOT ATTEMPT TO OPERATE IF PROTECTION MAY BE
IMPAIRED
If the device appears damaged or operates abnormally, protection may be
impaired. Do not attempt to operate the device under these conditions. Refer all
question of proper device operation to qualified service personnel.
DO NOT ATTEMPT TO SERVICE UNLESS YOU ARE A
FLUKE QUALIFIED REPAIR TECHNICIAN
To avoid personal injury or death, remove the AC power cord and all analog and
digital connector modules before servicing the device.
All signals must be removed from the analog and digital connector
wiring before opening the connector modules.
XWWARNING
Note
iv