Using The Digital I/O Points Communication Dialog - Fluke Data Acquisition System/Data Logging System 2680A Getting Started Manual

Data acquisition system/data logging system

Hide thumbs Also See for Data Acquisition System/Data Logging System 2680A:

Table of Contents

Getting Started

Managing Your Network Using Fluke DAQ

Using the Digital I/O Points Communication Dialog

You can use the Digital I/O Points Communication dialog to set any of the 8 relays

or 20 DIO pins active when an alarm condition occurs in the channel. You can also

view status of all of the relays and DIO pins and set or clear IO bits and relays.

Bits or relays you set display a green dot. Bits or relays set by an alarm have a red

dot. A bit set by an external signal has a blue dot. There is no way to set a relay

externally. When a relay is set, it has closed contacts. When a bit is set, it has a

logic low signal (also called active low).

To view digital I/O points dialog

1. Click the

on the Fluke DAQ toolbar.

2. Highlight an I/O module in the TreeView panel and the Digital I/O Points

dialog appears.

alg125s.bmp

Table of Contents

2686a