Setting Image Reverse - Mitsubishi Electric DLP UD8400U User Manual

Setting up your projector (continued)
Setting the projector posture
You can select the posture of the projector. Set
COOLING CONDITION in the INSTALLATION 1 menu
according to the posture.
Important:
the menu settings may cause breakdown or failure
of the projector or the lamp.
mode, the selectable projector posture is floor
installation (0°) and ceiling installation (180°) only.
Setting the projection angle
COOLING CONDITION in the INSTALLATION
1 menu referring to the figure below. The default
setting is 0°.
Projection angle setting
Angle range
135°
135˚ ± 30˚
180°
180˚ ± 15˚
Ceiling installation
225°
225˚ ± 30˚
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select COOLING CONDITION by pressing the  or
 button.
COOLING CONDITION
3. Press the ENTER button.
COOLING CONDITION
COOLING CONDITION
4. Select the angle by pressing the  or  button.
5. Press the ENTER button.
Important:
inconsistent with the actual projection angle, the
cooling condition setting dialog appears. In this
case, select the projection angle using the  or 
button and then press the ENTER button.
Straight up
90°
90˚ ± 15˚
45°
45˚ ± 30˚
0˚ ± 15˚
Floor installation
315°
315˚ ± 30˚
270°
270˚ ± 15˚
Straight down
0°
0°
Setting HIGH ALTITUDE MODE
1 menu according to the altitude at which you use
the projector. The default setting is STANDARD.
altitude from 0 to 2000 meters.
an altitude from 2000 to 2700 meters.
Important:
at an altitude higher than 2000 meters, the
projector may break down or fail.
mode, only floor installation and ceiling installation
are allowed.
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select HIGH ALTITUDE MODE by pressing the 
or  button.
3. Press the ENTER button.
0°
4. Select STANDARD
pressing the  or  button.
5. Press the ENTER button.

Setting IMAGE REVERSE

according to the orientation of the projector. The
default setting is OFF.
and front projection.
ceiling installation and front projection.
installation and rear projection.
installation and rear projection.
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select IMAGE REVERSE by pressing the  or 
button.
3. Select OFF, MIRROR, INVERT or MIRROR INVERT
by pressing the  or  button.
EN-13
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
or HIGH ALTITUDE
IMAGE REVERSE
STANDARD
STANDARD
by
OFF