Download  Print this page

Advertisement

Table of Contents
Advanced features (continued)
Split
You can split the screen in two and display a computer
image on the left screen and a video image on the
right screen.
Left screen
To use the split mode:
1. Press the SPLIT button on the remote control.
screens display the following images:
- Left screen: Image supplied to the last
- Right screen: Image supplied to the last
When you press the SPLIT button again, the
screen is displayed in the normal mode.
change the input source, the screen is displayed
in the normal mode.
of the input source in the normal mode to be
displayed on the left screen are reflected on the
entire screen.
When no signal is input, a blue screen is
displayed.
screen, the displayed image may shake up and
down slightly, but this is not a malfunction.
When you display 60-Hz and 50-Hz video
signals at the same time, motion images may
not be displayed properly. In this case, set VERT.
SYNC. of USER in the SIGNAL menu to OFF for
the left screen. (See page 39.)
menu is set to IMAGE, you cannot use the split
mode unless a video signal is being input.
some time depending on the signal.
To change the input source of the left or right screen:
To change the input source of the left screen, press
the  button on the remote control.
To change the input source of the right screen,
press the  button on the remote control.
Right screen
selected input source,
COMPUTER1, COMPUTER2,
DVI, HDMI, or SDI (for UD8400U
and UD8400LU only)
selected input source, VIDEO
or S-VIDEO
Freeze
To stop the motion in the image temporarily (or to
display a still image):
Press the FREEZE button on the remote control.
The image will freeze temporarily.
To resume the motion in the image:
Press the FREEZE button on the remote control again.
Important:
because the afterimages may persist on the screen.
EN-57

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric DLP UD8400U

Comments to this Manuals

Symbols: 0
Latest comments: