Mitsubishi Electric DLP UD8400U User Manual page 47

Adjusting projected images (continued)
Adjusting the image displayed on
the multi-screen
You can configure a multi-screen display using
multiple projectors.
You can make the joints of the images displayed on
the projectors unnoticeable and adjust the differences
in the brightness and the color tint of them.
Important:
image may fluctuate due to the effect of the exhausted
wind. In such a case, open up the space between
the projectors so that the image doesn't fluctuate
(approximately 70 cm or more).
Making the joints unnoticeable
You can make the joints of the images projected on
the projectors unnoticeable using the menu settings.
(See page 32 for menu setting.)
1. Display the MULTI-SCREEN menu.
2. Select EDGE BLENDING by pressing the  or 
button.
EDGE BLENDING
3. Select ON by pressing the  or  button.
4. Select SETTING by pressing the  or  button.
SETTING
5. Select EDGE ADJUST
button.
6. Press the ENTER button.
SETTING - EDGE ADJUST
EDGE SELECT
BLENDING
WIDTH
MARKER
7. Select an item you want to set by pressing the  or
 button.
EDGE SELECT
Select the joint you want to adjust from UP, LOW,
LEFT, and RIGHT.
BLENDING
When you select ON, the joint selected by EDGE
SELECT becomes unnoticeable.
WIDTH
Set the width of the overlap of the joint selected by
EDGE SELECT.
When UP or LOW is selected:
When LEFT or RIGHT is selected: 4 to 944
MARKER
When you select ON, a marker for easily locating
the overlap of the joint is displayed.
8. Select a setting value by pressing the  or  button.
Repeat steps 7 to 8, if necessary.
9. Press the MENU button once.
10. Select BLACK LEVEL
button.
SETTING
OFF
EDGE ADJUST
by pressing the  or 
UP
OFF
128
OFF
4 to 524
by pressing the  or 
BLACK LEVEL
11. Press the ENTER button.
SETTING - BLACK LEVEL
INTERLOCKED
RED
GREEN
BLUE
12. Select an item you want to set by pressing the  or
 button.
overlapped areas.
adjust RED, GREEN, and BLUE simultaneously.
When you set it to OFF, you can adjust RED,
GREEN, and BLUE separately.
13. Select a setting value by pressing the  or  button.
Repeat steps 12 to 13, if necessary.
14. Press the MENU button once.
15. Select BRIGHT UNIFORMITY CORRECTION
pressing the  or  button.
the projected images is made even.
SETTING
16. Press the ENTER button.
dialog box and the correction position marker
are displayed.
BRIGHT UNIFORMITY CORRECTION dialog box
Every time you press the ENTER button, the
BRIGHT UNIFORMITY CORRECTION dialog box
shows POSITION and LEVEL alternately.
POSITION
POSITION :
SELECT : ENTER
LEVEL
LEVEL
: 100
SELECT : ENTER
17. Cancel the BRIGHT UNIFORMITY CORRECTION
dialog box.
Press any button other than the , , , or ,
and ENTER buttons to clear the dialog box.
Or, the dialog box disappears in 10 seconds after
the last use.
To cancel the menu:
18. Press the MENU button.
EN-47
ON
0
0
0
BRIGHT UNIFORMITY
CORRECTION
POSITION :
SELECT : ENTER
Correction position marker
Press the , , , or 
button to move the correction
position marker.
Press the , or  button to
adjust the correction amount.
by