Preparing Your Projector - Mitsubishi Electric DLP UD8400U User Manual

Preparing your projector

Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in
the package.
Cables
Mini D-SUB
15-pin
RGB cable for PC
(246C597-20)
Remote control parts
Remote control
(290P188-10)
Important:
1
2
Caution:
contact with your eyes, rinse them with water and then consult your doctor.
D-SUB
9-pin
Mini D-SUB
15-pin
Used for projector control
by computer.
R6 (size-AA)
battery (two)
3
D-SUB
9-pin
RS-232C cable
(246C598-20)
Inserting the batteries into the remote control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
the (-) side is difficult because the coil spring end hits
on the battery side. If the battery is forced to insert in
this way, the outer label of the battery may get ripped
and it may cause a short-circuit and heating.
3. Attach the rear lid.
Important:
control is slow to operate.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the
batteries.
EN-6
Power supply parts
Power cord (two)
(246C684-10, 246C383-20)
Others
Lens cap (attached to the projector)
Terminal cover
Lamp replacement tray
CD-ROM
Safety Manual/Quick Start up
Mitsubishi logo plate
Control panel label for ceiling installation
Terminal block label for ceiling installation