Download  Print this page

Correcting Skewed Or Distorted Image; When The Projected Image Is Distorted; Setting Image Reverse - Mitsubishi Electric UD8900U User Manual

Dlp.
Hide thumbs

Advertisement

Table of Contents
Setting up your projector (continued)
Setting HIGH ALTITUDE MODE
1 menu according to the altitude at which you use
the projector. The default setting is STANDARD.
altitude from 0 to 2000 meters.
an altitude from 2000 to 2700 meters.
Important:
at an altitude higher than 2000 meters, the
projector may break down or fail.
mode, only floor installation and ceiling installation
are allowed.
(See page 31 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select HIGH ALTITUDE MODE by pressing the 
or  button.
HIGH ALTITUDE MODE
3. Press the ENTER button.
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
4. Select STANDARD
pressing the  or  button.
5. Press the ENTER button.

Setting IMAGE REVERSE

according to the orientation of the projector. The
default setting is OFF.
and front projection.
ceiling installation and front projection.
installation and rear projection.
installation and rear projection.
(See page 31 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select IMAGE REVERSE by pressing the  or 
button.
IMAGE REVERSE
3. Select OFF, MIRROR, INVERT or MIRROR INVERT
by pressing the  or  button.
STANDARD
STANDARD
or HIGH ALTITUDE
by
OFF

Correcting skewed or distorted image

For the best projection, project images on a flat screen
installed at 90 degrees to the floor. If necessary, tilt the
projector using the two adjustment feet on the bottom
of the projector.
1. Tilt up the projector to the appropriate angle.
2. Rotate the adjustment feet for fine adjustment.
Important:
feet extended. Otherwise the adjustment feet may
be damaged.
When fine streaks are seen on
projected images
This is due to interference with the screen surface and
is not a malfunction. Replace the screen or displace
the focus a little. (See page 12 for focus adjustment.)
When the projected image is
distorted:
When the projected image is distorted, carry out any
of the KEYSTONE, CORNERSTONE, and CURVED-
mode adjustments to correct the distortion.
When the image distorts in a trapezoid shape, use the
KEYSTONE-mode adjustment. For fine adjustment
of the image shape, use the CORNERSTONE-mode
adjustment. To adjust the image projected on a curved
surface, use the CURVED-mode adjustment.
When you press the ENTER/GEOMETRY button on
the projector or the GEOMETRY button on the remote
control, the menu switches in the order of KEYSTONE,
CORNERSTONE, CURVED, regular display, KEYSTONE...
EN-13
Screen
Adjustment feet

Advertisement

Table of Contents

   Also See for Mitsubishi Electric UD8900U

   Related Manuals for Mitsubishi Electric UD8900U

This manual is also suitable for:

Ud8850u

Comments to this Manuals

Symbols: 0
Latest comments: