Mitsubishi Electric DLP UD8400U User Manual page 54

Lamp relay (continued)
selection, or during the lamp relay operation, you
cannot change the setting of LAMP SELECT and
LAMP RELAY.
deteriorate earlier unless they are turned off for 1
hour per week.
time of period, enable LAMP RELAY.
lamp switching.
When LAMP SELECT is set to SINGLE:
The lamps are automatically switched and used alternately.
(See page 32 for menu setting.)
1. Display the INSTALLATION 1 menu.
2. Select LAMP SELECT by pressing the  or  button.
2
LAMP SELECT
1
3. Press the ENTER button.
by pressing the  or  button.
4. Select SINGLE
LAMP SELECT
2
LAMP SELECT
1
5. Press the ENTER button.
6. Select LAMP RELAY by pressing the  or  button.
LAMP RELAY
7. Select 24H or 1 WEEK
button.
24H ......... The lamps are switched to each other
every day.
At the time of power-on or menu setting
2
1
Illuminating
Off
LAMP 1
LAMP 2
1 WEEK .. The lamps are switched to each other
every week.
At the time of power-on or menu setting
1 2
LAMP 1
LAMP 2
8. Press the ENTER button.
to set the lamp relay interval is displayed.
24H
NEXT LAMP RELAY
2 4 H
0 1 2 3 4
OK
DUAL
SINGLE
24H
by pressing the  or 
3 4 5 6 7
3 4 5 6 7
Off
Illuminating
or 1 WEEK , the box
DEL
5 6 7 8 9 CLEAR
CANCEL
1 WEEK
9. Move the key cursor using the direction buttons to
select the number you want to enter and then press
the ENTER button.
24H
1 WEEK
  key:
  key:
DEL key:
CLEAR key: Deleting all the entered characters.
buttons (0 to 9) while holding down the NUM
button on the remote control.
conditions, an error dialog box is displayed at
the screen center.
∙ The value has been cleared by DEL or CLEAR
and left blank.
∙ The value you entered is out of the setting
range.
∙ The value of each item is out of the setting
8 (days)
range.
10. When selecting OK, the setting is completed as
the lamp-switching interval stored. However, when
selecting CANCEL, the setting is completed without
storing.
8 (days)
selecting OK or CANCEL.
RELAY in the INFORMATION menu.
Important:
relay may not be performed on time due to errors of
the clock function.
selection, or during the lamp relay operation, you
cannot change the setting of LAMP SELECT and
LAMP RELAY.
deteriorate earlier unless they are turned off for 1
hour per week.
time of period, enable LAMP RELAY.
lamp switching.
EN-54
NEXT LAMP RELAY
7 D 0 0 H
0 1 2 3 4 5 6 7 8
OK CANCEL
........... 24H (24 hours)
.... 7D 00H (7 days and 00 hours)
S hifting the position of enter cursor
to the left for each character.
Shifting the position of enter cursor
to the right for each character.
Deleting the character in the
position of enter cursor for each
character.
24H ......... 25H or over
1 WEEK ... 7D 01H or over
D .................. 8 or over (1 WEEK
H .................. 25 or over
DEL
9 CLEAR
only)