Table of Contents
Advertisement
■ ■ ■ ■ ■ Line thickness
This setting is used to adjust the line width of vector graphics. For example, if you desire a finer line, select a value
from 0 to 4. If you desire a thicker line, select a value from 6 to 9. To return to the standard line thickness, select 5.
Use this setting for special applications such as CAD when lines do not appear with sufficient clarity. For regular
applications, there is usually no need to change the setting.
Default setting: 5
The relation between the setting values and the change of line thickness are as follows.
Value
Thickness change
1 dot *
All lines are 1-dot lines.
1
*
■ ■ ■ ■ ■ Extra print mode
When you have a large number of single print jobs, this setting can be used to shorten the waiting time between
print jobs and increase efficiency. Normally there is no need to turn this setting on.
When this setting is turned on, multiple single print jobs are displayed in the Job status screen as one print job.
Note that the "Notify Job End" function does not operate (even if turned on) when Extra print mode is turned on.
When turned on, Extra print mode combines single print jobs into one print job. However, if any of the print jobs are
as described in A or B below, Extra print mode will turn off or stop functioning.
A. One of the following print conditions change between print jobs:
Two-sided printing to one-sided printing / one-sided printing to two-sided printing / binding method of two-
sided printing / orientation of two-sided printing / paper type / output tray / toner save / smoothing / binding
position / binding width / halftone *
*
1
An optional PS3 expansion kit is needed.
B. One of the following print modes is selected for a print job:
Account control / Two or more copies / Job retention *
Transparency inserts
*
2
An optional hard disk drive must be installed.
PCL settings
PCL SETTINGS is used to assign a part of character codes to characters of a country in the PCL symbol set. (Used
when different symbols are used depending on the country.)
Default setting: "1" (Roman-8)
For setting items of the symbol set, see page 7-6.
The list of the numbers to be set and their corresponding symbol sets can be printed using "PCL symbol set list
printing" (see page 3-8).
When using the operation panel on the main unit, select the desired symbol set item and register it. When using the
operation panel with touch panel, select the number that corresponds to the desired symbol set and register it.
PostScript settings
This setting specifies whether an error page describing the cause of an error is printed or not when a PostScript error
has occurred.
Selections are available to choose printing or not printing of error pages.
Default setting: Not print
0
1
2
1
50%
75%
90%
1
MAKING CONFIGURATION SETTING
3
4
5
95%
100%
105%
2
/ Saddle stitch / Staple / Punch / Different first page /
6
7
8
110%
125%
150%
9
3
3-5
Advertisement
Table of Contents
Troubleshooting
