Sharp AR-3551 Operation Manual page 114

KEY OPERATOR PROGRAMS
Disable finisher
This program is used to disable use of the saddle
stitch finisher or finisher when it malfunctions.
{Disabling of finisher}
Same as for the main unit.
Disable mail-bin stacker
This program is used to disable use of the mail-bin
stacker when it malfunctions.
{Disabling of mail-bin stacker}
Same as for the main unit.
Saddle stitch adjust
This program is used to adjust the stapling position
(folding position) when using the saddle stitch
function of the saddle stitch finisher.
The value can be adjusted in 0.1 mm increments
within ±3.0 mm from the reference position for each
paper size.
{Saddle stitch position adjust}
Same as for the main unit.
Max. +3 mm
Position adjusted
to the plus
direction
1
2
Reference position
High speed stacking
This program is used to have print speed priority,
which is available for printing in the offset mode with
the saddle stitch finisher.
When this program is on, slight decrease of stacking
performance might occur.
This program is set in the factory default setting.
{High speed stacking}
Same as for the main unit.
6-10
Min. -3 mm
Position adjusted
to the minus
direction
12
11
Rotated output
When Rotated output is turned on, you can have
the paper output orientation (A4-size paper only) of
each set of copies alternate between horizontal and
vertical. This function is used to sort output when
neither the Finisher peripheral nor the Saddle stitch
finisher peripheral are installed.
* To use this function, A4-size paper must be loaded
both horizontally and vertically in the paper trays.
This function works when paper is output to the
upper paper output area of the laser printer, the
exit tray of the Duplex module peripheral, or the
top tray of the Mail-bin stacker.
The function does not work in the following cases:
• When paper is output to the Finisher peripheral or
the Saddle stitch finisher.
• Printing in Group mode.
• When a letter-size original is printed on A4-size
paper using the "A4/LT auto select {A4/letter size
auto change}" key operator program (page 6-11).
• When "Transparency Inserts" or "Different Paper"
is selected in the printer driver.
• When "Paper Source" under "Paper Selection" in
the printer driver is set to any selection other than
"Auto Select".
• When the printing paper size for a stored job or a
job in progress has been overridden and changed
to A4 size.
NOTE
When interrupt copying is performed, Rotated output
does not take place to distinguish the output of
regular copying from interrupt copying. Also, Rotated
output cannot be used to sort output by job.
■ Print key operator programs list
This program is used to print out the list of the key
operator programs.
{List print}
Key operator programs for copier, facsimile feature,
and network scanner features can be printed.