SADDLE STITCH FINISHER
Misfeed in the saddle stitch finisher
When a misfeed occurs in the saddle stitch finisher, remove the misfed paper following the procedure below.
1
Unlatch the saddle stitch finisher and slide
it away from the printer.
2
Remove the misfed paper from the main
unit.
3
If misfed paper is not found in step 1, open
the top cover.
4
While pulling and turning roller rotating
knob B, remove the misfed paper.
5-24
After removing the misfed
paper, open and close
the duplex module to
reset the jam indicator.
(step 1 or 5 on page 4-4)
If the misfed paper is
released by turning roller
rotating knob B, remove
it taking care not to tear
the paper.
Roller rotating
knob B
5
Close the top cover.
6
If saddle stitch was selected, open the front
cover.
7
Remove the misfed paper from the stapler
compiler.
8
Open the saddle stitch section cover.
9
Remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
Be careful not to tear the
misfed paper during
removal.