Staple Cartridge Replacement And Staple Jam Removal - Sharp AR-3551 Operation Manual

[OK] key
Press to close the [OUTPUT] screen and to return
to the basic screen.
[OFFSET] key (See page 5-18.)
When the offset tray is selected, copies will be
delivered to the offset tray. When staple sort is
selected, the offset tray will be automatically
selected.

Staple cartridge replacement and staple jam removal

When the staple cartridge becomes empty or staples become jammed, a message will appear in the message display
of the operation panel.
Follow the procedure below to replace the staple cartridge or remove jammed staples.
■ Staple cartridge replacement
1
Open the front cover.
2
Pull out the stapler section.
3
Turn roller rotating knob A in the direction
of the arrow to move the staple unit to the
front.
Roller rotating knob A
Staple unit
4
Remove the empty staple box.
Turn the roller rotating
knob until the triangle
mark is aligned with the
index.
SADDLE STITCH FINISHER
[SADDLE STITCH] key (See page 5-19.)
When saddle stitching is selected, the copies will be
stapled at the center and delivered to the saddle stitch
tray.
[PUNCH] key (See page 5-19.)
If the saddle stitch finisher is equipped with a hole
punch module, printed paper can be three-hole
punched and delivered to the offset tray.
5
Remove the empty staple cartridge.
NOTE
If staples remain, the staple cartridge cannot be
removed.
6
Insert a new staple cartridge into the staple
box.
NOTES
● Do not remove the tape from the cartridge before
inserting the staple cartridge into the box.
● When reinstalling the staple box, push it in until it
clicks into place
.
7
Remove the tape from the staple cartridge
by pulling it straight.
Press the lock button to
unlock the staple box
cover and remove the
staple cartridge.
After inserting the staple
cartridge, press down on
the staple box cover to
lock the cartridge in place.
5-21
5