Ep-35 Temperature Configuration - Lowrance LMF-200 Installation And Operation Instructions Manual

Multi-function gauge

Hide thumbs Also See for LMF-200:

Installation and operation instructions manual (44 pages)

Table Of Contents

Table of Contents

Section 4: EP Configuration &

To configure items connected to the LowranceNET network, press

and select

which will open the Bus Devices list, a list of devices on the network.

Bus Devices works as the device manager for the bus, allowing you to

configure and unconfigure devices and set and reset critical values such

as alarms and calibration.

If you configure or reconfigure a sensor, you are assigning or

reassigning its configuration name in the LMF-200 to a different sensor

location on the boat.

NOTE:

The Suzuki Engine Interface, EP-10 Fuel Flow, EP-15 Fluid Level,

EP-35 Temperature Sensor and EP-50 Storage Device are the only

devices that can be configured through the Bus Devices list.

The following items can be configured, unconfigured or reconfigured:

Temperature (UnCfg Tmp), Fuel Flow (UnCfg FF) and Fluid Level

(UnCfg FL) sensors. When they are shown on the bus devices list as

UnCfg Tmp, UnCfg FF and the UnCfg FL, they are unconfigured.

You can have multiple Temperature sensors and Fluid Level Tanks,

but will have no more than three Fuel Flows to configure since the

LMF-200 supports a maximum of three engines on a vessel.

NOTE:

If you configure the desired sensors and are not satisfied with the

results, you may clear the configuration settings for each sensor

individually, by resetting values from the sensor's configuration

menu. Remember, ONLY the sensor you select from the Bus

Devices list will be set back to its defaults.