Table of Contents
Advertisement
NOTE:
If the difference between the LMF-200 fuel used figure and the
amount of fuel you actually added to the tank is less than 3 percent
the EP-10 Fuel Flow does not need to be calibrated.
7. To recalibrate the unit, fill up the fuel tank connected to the fuel flow
you want to calibrate.
8. Press
MENU
press
.
MENU
9. Highlight
F
The Select Tank menu will open with three options: Port, Cen (Center)
and Stbd (Starboard). Select the tank you refilled and press
10. The Recalibration (The Recal?) menu will appear with two options:
Yes and No. Select
11. The Filled Quantity window will appear. Use the
keys to input the amount of fuel you added to the tank and press
14. Repeat these steps for each fuel flow you want to calibrate.
NOTE:
It is a good idea to check the calibration of a fuel flow periodically.
Reset Calibration
The Reset Calibration command allows you to reset a fuel flow back to
factory default settings.
To execute Reset Calibration command:
1. Press
MENU
press
.
MENU
2. Highlight
B. D
reset and press
3. Select
R
ST
following message will appear: Hit Menu to Rst the Cal.
4. Press
MENU
recalibrate the fuel flow, follow the steps in the previous segment
regarding fuel flow calibration.
Partial Fill
You will use the Partial Fill option each time you add fuel but do not
fill up the tank.
To use Partial Fill:
1. Press
MENU
press
.
MENU
2. Highlight
. The Select Tank menu will open with three options: Port, Cen
MENU
, use the
UP
and press
UEL MNGR
and press
Y
ES
, use the
UP
and press
EVICES
.
MENU
from the fuel flow menu and press
C
AL
to set calibration back to factory default settings. To
, use the
UP
and press
F
UEL MNGR
and
keys to select
DOWN
. Select
MENU
.
MENU
and
keys to select
DOWN
. Select the fuel flow you want to
MENU
and
keys to select
DOWN
MENU
50
S
. and press
R
T
EFILL
S
S
. Select
P
ART FILL
and
S
YSTEM
ETUP
MENU
.
MENU
and
UP
DOWN
MENU
and
S
YSTEM
ETUP
. The
MENU
and
S
YSTEM
ETUP
. and press
.
.
Hide quick links:
Advertisement
Table of Contents
