Table of Contents
Advertisement
Chapter 9: Message transfers
9-1 Message sending procedures and data reception details
This section describes procedures used for the settings needed to send (or request) messages using
the message transfer function, as well as the details for receiving data from a node. (JW-50FL general
setting procedures
1 Setting the parameters
1
1
1
1
Specify the transmission buffer area that will be used to send (request) and receive (response)
messages.
1) Specify the area for the transmission buffer
9
2) Set the transmission buffer to "Used"
3) Set the start switch
To the next page
See page 8-3.)
This node
(Host PC
for the JW-
50FL
When the top address of the transmission buffer has been entered, the area (address +
0000 to 4055
: 2094 bytes) will be allocated. Enter the top address at parameter address
(8)
(34 to 36
).
(8)
Parameter
address
(8)
34
Top address (word address) of transmission buffer
- Address 34 is for the lower digit. Address 35 is for the upper digit.
35
36
File number of the transmission buffer
Select whether or not to enable each message classification. Enter your choices at
parameter address 37
.
(8)
Parameter
address
(8)
37
Enable/disable use of a transmission type buffer
Message
Message other than transmission
Messages other than SHARP's proprietary
message format
Transmission
message
SHARP's
proprietary format
Change the parameter setting at address 77
details for the control module to the JW-50FL.
Parameter address
(8)
77
Send data (request)
Receive data (response)
Details
(Parameter details
Details
Computer link function
Remote function
from 00
(8)
Detail
Start switch
9-2
Node
used to
exchange
data
See Chapter 12.)
Setting value
80
81
82
(H)
(H)
(H)
O: Used X: Not used
to 01
, and transfer the setting
(H)
(H)
83
(H)
Advertisement
Table of Contents
