Table of Contents
Advertisement
Assemble the coaxial cable connector
Note: The gap between the center pin and the insulator should not be larger than 1 mm. The insula-
tion material must be intact.
(5) Transceiver
Installing and securing a tap type transceiver
The method and location for installing a transceiver depends on the local conditions. However,
common installation locations are as follows.
Install on a wall
Install in the free access space under the floor
Install in the ceiling or in a cable rack
Install near a station
The precautions when installing a transceiver are as follows:
Secure the transceiver on the floor or a flat surface using foot, or secure it using self-tapping
screws.
When installing a transceiver in the ceiling or below the floor, select a location that is easy to
access for maintenance and checking.
The installation distance between transceivers is 2.5 m. (Use the markers on the cable that are
spaced every 2.5 m)
15-45
Chapter 15: Appendix
15
Advertisement
Table of Contents
