Table of Contents
Advertisement
8-3 Parameter settings for cyclic transfers
The parameters related to cyclic transfers are as follows.
Parameter
address
(8)
10
2
11
12
3
13
14
5
15
16
6
17
20
1
21
22
24
4
25
26
Corresponds to 1 to 6 on page 8-1.
- Enter the top address in word units (* above).
Ex.: Enter 1600 to 1601 (word address 01C0
and 11
.
(8)
Parameter address
Set value (HEX)
Top address (word address) of the data sending areas of own node area 1 *
- Address 10 is for the lower digit and 11 is for the upper digit.
Sending data length (word) of own node area 1
- Address 12 is for the lower digit and 13 is for the upper digit.
Top address (word address) of the data sending areas of own node area 1 *
- Address 14 is for the lower digit and 15 is for the upper digit.
Sending data length (word) of own node area 1
- Address 16 is for the lower digit and 17 is for the upper digit.
Top address (word address) of area 1 on a PC *
- Address 20 is for the lower digit and 21 is for the upper digit.
File number of area 1 on the PC.
Top address (word address) of area 2 on a PC *
- Address 24 is for the lower digit and 25 is for the upper digit.
File number of area 2 on the PC.
(Upper digit) 11
01
8-7
Description
(For parameter details
Pages 8-8 to 8-12.
) as the top address at parameter addresses 10
(H)
(Lower digit) 10
C0
Chapter 8: Cyclic Transfer
See Chapter 12.)
8
Advertisement
Table of Contents
