Receive; When The Module Is Used (Host Pc: Jw30H, J-Board (Z-500 Series)) - Sharp JW-20FL5 User Manual

[2] RECEIVE

This function operates by the combination of F-203 (OPCH) and F-205 (RCV).

(1) When the module is used (host PC: JW30H, J-board (Z-500 series))

F-203
UN-
CH-ST fileN
OPCH
F-204
n
SEND
UN : Module No. switch set value (0 to 6) of the communication
module
CH : Channel number within the specified module (board) (0 to 3).
In the PC program, the same port number can be called 4
times, once for each channel (CH0, CH1, CH2, and CH3).
ST : Target node number (01 to FE
fileN : Data area in the target node PC (file number)
S : Top file address of the data area in the target node PC
n : Number of data bytes transmitted (000 to 377
000)
D : Data area top register of source station data
This node
Setting target node
file 0
D
Flag
Flag status during and after the operation
Zero
07357
No response
from the module
(board)
Communi-
cation jam
Communi-
cating
Normal end
Abnormal end
(timeout)
S
D
)
(H)
CH number
corresponding to
the UN number
Non-
Carry Error
carry
07356 07355
07354
0 0 1 0
0 0 0 1
1 0 0 1
0 1 0 0
0 1 1 0
11-5
Chapter 11: SEND/RECEIVE function
, 256 bytes at
(8)
Target node
file N
S
Send
Response
Description
Set value on the UN and module No. switch set
value of the communication module are different.
This condition may instantaneously occur while
other receive instruction is being executed.
However, as soon as the condition becomes clear
for the execution of an instruction, the status will
turn to "Communicating."
The communicating is being run. Once the
communication completes, the status will change
to either "normal end" or "abnormal end."
When the receive instruction has successfully
completed.
When there is no response from target node.
0000 to 1577
2000 to 7577
b0000 to b1777
b2000 to b3777
09000 to 99777
E0000 to E7777
File1 000000 to 037777
@ 0000 to @ 1574
@ 2000 to @ 7574
@b0000 to @b1774
@b2000 to @b3774
@09000 to @99774
@E0000 to @E7774
File1 @000000 to @037774
n
11