Table of Contents
Advertisement
Chapter 14: Specifications
14-3 JW-50FL
[1] General specifications
Host PC
Storage temperature
Ambient operating
temperature
Ambient humidity
Vibration resistance
Impact resistance
Internal current consumption
(5 VDC)
External supply power
Ethernet interface
Programmer interface
Weight
Accessory
*1: The JW-50FL cannot be installed on a W70H/100H.
[2] Communication specifications
(1) Communication section specifications
Network compatibility
Transfer speed
Physical topology
Transfer media
Transfer system
Maximum transfer distance
Protocol configuration
Application
Transport
Network
14
Data link
*2: Maximum transfer distance between stations when connecting more than one segment using re-
peaters.
*3: Maximum transfer distance between stations when connecting more than one 10BASE-T segment
using hubs.
Item
Install in optional slots on the JW50/70H/100H (max. 5 units) *1
-20 to +70˚ C
0 to +55˚ C
35 to 90% RH (without condensing)
Equivalent to JIS C 0911: Vibration test: width 0.15 mm (10 to 58
Hz), 9.8 m/s
Equivalent to JIS C 0912: 98 m/s
400 mA
12 VDC ±5%, 0.5 A (only needed for 10BASE5 systems)
AUI for 10BASE5 (D-sub 15-pin)
10BASE-T (RJ-45 connector)
D-sub 25-pin
Approx. 380 g
One cable, one instruction manual
Item
10BASE5 or 10BASE-T
10M bps
Bus (10BASE5) / Star (10BASE-T)
50 ohm yellow cable (10BASE5), twisted pair cable (10BASE-T)
Base band
10BASE5: 500 m/segment, 2.5 km/network *2
10BASE-T: 100 m/segment, 500 m/network *3
FA link protocol
UDP
IP
Ethernet V2
Specifications
2
(58 to 150 Hz), (2 hours each on the X, Y, Z axes)
2
(3 each on the X, Y, Z axes)
Specifications
14-4
Advertisement
Table of Contents
