Adjusting The Height And The Inclination Of The Feed Dog - JUKI LH-3528 Instruction Manual

6-5. Adjusting the height and the inclination of the feed dog

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1mm
2
4
A
B
3
1
3
5
C
– 28 –
(1) Adjusting the height
) Loosen bottom feed link setscrew 1 , and turn
feed driving link shaft 2 to adjust the height.
Standard height is  mm from the throat plate
in the highest position.
(2) Inclination
) Remove cap 4 on the side of machine bed,
loosen feed bar shaft setscrew 3 , and turn
knurled section 5 to adjust the inclination.
Standard inclination is the position where
engraved marker dot A of feed bar arm aligns
with engraved marker dot B of feed bar shaft.
(Engraved marker dot C is for LH-400.)