Dip Switch Settings; Features - IMC Networks iMcV-DS3/E3-LineTerm Operation Manual

DIP Switch Settings

FUNCTION
2
Loopback (iView Configurable)
Loopback Type (iView
Not Used
Fault Loopback (iView
Line Build-Out
Transmit Coax Data Source (iView
DS3/E3/STS-1 Selection
Remote Management

Features

The iMcV-DS3/E3-LineTerm module includes several features that allow it to be
configured for DS3, E3, or STS-1-based environments.
Loopback (DIP Switch S1, Position 1)
This switch enables or disables the loopback feature. When this feature is enabled,
the data line (Coax or Fiber) set by the "Loopback Type" DIP switch is looped back.
By default this feature is DISABLED.
This feature can be controlled by SNMP management software (iView
iMcV-DS3/E3-LineTerm module, configured as a HOST, is installed in a managed
chassis.
SWITCH SETTINGS
S1-1: OFF
S1-1: ON
2
Configurable)
S1-2: OFF
S1-2: ON
S1-3: OFF
S1-3: ON
2
Configurable)
S1-4: OFF
S1-4: ON
S1-5: OFF
S1-5: ON
2
Configurable)
S1-6: ON 7: ON
S1-6: OFF 7: ON
S1-6: ON 7: OFF
S1-6: OFF 7: OFF
S1-8: ON 9: OFF
S1-8: OFF 9: ON
S1-8: ON 9: ON
S1-10: OFF
S1-10: ON
RESULT [(D) = Default]
Loopback Disabled (D)
Loopback Enabled
Coax (D)
Fiber
Fault loopback Disabled (D)
Fault loopback Enabled
0 to 255 ft. (D)
> 255 ft.
Standard Data (D)
Unframed All Ones
Alternating Ones & Zeros
Pseudorandom Bit Sequence
45 Mbps (DS3) (D)
34 Mbps (E3)
52 Mbps (STS-1)
Remote Management Disabled (D)
Remote Management Enabled
3
2
) when the