Installation; Initial Settings; Recording Screen - Automatic Mode - 3Com VCX V7111 User Manual

Installation

The CPTWizard can be installed on any Windows 2000 or Windows XP based PC.
Windows-compliant networking and audio peripherals are required for full functionality.
To install the CPTWizard, copy the files from the supplied installation kit to any folder on your
PC. No further setup is required (approximately 5 MB of hard disk space are required).

Initial Settings

To start the CPTWizard, follow these steps:
1
Execute the CPTWizard.exe file; the wizard's initial settings screen is displayed.
Figure 106 Initial Settings Screen
2
Enter the IP address of the VCX V7111/FXO gateway you are using.
3 Select the gateway's ports that are connected to your PBX, and specify the phone
number of each extension.
4
In the Invalid phone number field, enter a number that generates a "fast busy" tone
when dialed. Usually, any incorrect phone number should cause a "fast busy" tone.
5
Press Next.
The CPTWizard communicates with the VCX V7111/FXO gateway via TPNCP. If this protocol
has been disabled in the gateway configuration, the CPTWizard doesn't display the next
screen and an error is reported.
Recording Screen – Automatic Mode
After the connection to the VCX V7111/FXO gateway is established, the recording screen is
displayed.
240 3Com VCX V7111 VoIP SIP Gateway User Manual