HP NonStop TMF Programming Manual page 86

Commands and Responses
ZTMF-VAL-Scratch
specifies that the tape volume can be used for dumping files.
ZDensity
specifies the density at which the tapes are written. This field is only valid if
ZLabelMedia is ZSPI-VAL-True. The following values are valid:
ZTMF-VAL-Default
ZTMF-VAL-800BPI
ZTMF-VAL-1600BPI
ZTMF-VAL-6250BPI
ZTapeMode
specifies the kind of write operation performed by the tape drive and is
applicable only for streaming tape drives. This field is only valid if ZLabelMedia
is ZSPI-VAL-True. The following values are valid:
ZTMF-VAL-StartStop
ZTMF-VAL-Stream
ZTMF-VAL-StreamSlow
ZTMF-VAL-StreamFast
If this field is null, the default value depends upon the tape drive. You can
specify either ZDensity or ZTapeMode, but not both in the same command.
ZTapeDrive
specifies the name of the tape drive on which you want to label tape volumes.
Guardian labeled-tape processing must be enabled on the node (system) you
specify. This field is required if the value of ZLabelMedia is ZSPI-VAL-True.
ZOperatorDevice
specifies the name of the device on which TAPECOM prompts are to be
displayed. This field is required if the value of ZLabelMedia is ZSPI-VAL-True.
Usage Guidelines
Only super-group users can issue this command.
For more information on the ADD TAPEMEDIA command, see the TMF Reference
Manual.
HP NonStop TMF Management Programming Manual—540140-008
If this field is null, the default value depends
upon the tape drive.
The density is 800 bits per inch.
The density is 1600 bits per inch.
The density is 6250 bits per inch.
5-22
ADD MEDIA