3172: Zpwy-Err-Tcp-Msgtoobig; 3173: Zpwy-Err-Tcp-Ctl26Error; 3174: Zpwy-Err-Tcp-Ctl26Timeout; 3175: Zpwy-Err-Tcp-Editerroroutput - HP NonStop Pathway/iTS Programming Manual

TCP Error Messages Error-Message Range 3000 Through 3999

3172: ZPWY-ERR-TCP-MSGTOOBIG

After conversion of message data from an unsupported format to a supported format,
the message length exceeded the maximum number of bytes allowed for all
messages.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. If the user conversion routine is causing the error, correct the routine. If
the user conversion routine is not causing the problem, specify a larger message area
in the SEND MESSAGE statement in your program. For instructions on how to locate
the problem within the program, see Additional Information for Terminal Errors on
page 12-3.

3173: ZPWY-ERR-TCP-CTL26ERROR

A file-system error occurred during a CONTROL-26 operation to the TERM object.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.

3174: ZPWY-ERR-TCP-CTL26TIMEOUT

A timeout occurred during a CONTROL-26 operation to the TERM object. The
operation did not complete within 60 seconds.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. If a front-end process is being used, verify that it handles CONTROL-26
properly; otherwise, this event can indicate a malfunctioning process or system
performance problem.

3175: ZPWY-ERR-TCP-EDITERROROUTPUT

An edit error occurred during output to an intelligent device.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
NonStop Pathway/iTS Management Programming Manual—426749-002
12 -35