Computer & Digital Controller Displays - Pitco SELV14 Installation & Operation Manual

SELV INSTALLATION & OPERATIONAL MANAUAL
14.3 COMPUTER & DIGITAL CONTROLLER DISPLAYS
If your appliance is equipped with a computer or digital controller it may display the following messages
on its display.
Display Problems
Controller is OFF
Oil/shortening temperature is low.
Fryer is slowly heating.
Oil/shortening temperature is low.
Fryer is slowly heating.
Oil/shortening temperature is low.
Fryer is heating.
Oil/shortening is at temperature
and ready to cook.
Drain valve is open while controller
is on.
Ignition system has locked out.
Incorrect probe reading.
Oil/shortening has reached an
unsafe temperature.
Incorrect probe reading.
Temperature probe is shorted.
This message indicates that oil in
the vat is in need of polishing.
34
Press [I/O] key to turn controller ON
Wait for appliance to heat up.
Wait for appliance to heat up.
Wait for appliance to heat up.
Perform cooking activites as needed.
Turn off appliance. Close drain valve
before turning appliance back on.
Refer to Fryer Troubleshooting section
Contact a qualified service technican.
Turn off appliance. Allow time for
applicance to cool before turning on.
Contact a qualified service technican.
Contact a qualified service technican.
Operators may (depending on settings)
polish now, or defer the polish filter
operation for a later time.
L20-406 Rev 5 (3/14)
Action