Hold Pre-Alarm; Spin Time; Spin Rate; To Exit Level 1 Programming - Pitco L22-355 Service Manual

2.2.4

Hold Pre-Alarm

Hold Pre-Alarm is a timer setting that is used to warn operators that the Hold Time is about to
expire. To use Hold Pre-Alarm, the time value must be a non-zero value, and, must be set to a
value less than Hold Time. Default value is zero, meaning the Hold Pre-Alarm is inactive.
 Display shows [nPA mm:ss] [TIME] where "n" is the key number, PA means Pre-Alarm,
and "mm:ss" is minutes and seconds.
 Use the product keys for numeric entry to adjust the current setting. Press the
to save pre-alarm time. Note: Value entered for hold pre-alarm time is the time from the
end of the hold period.
2.2.5

Spin Time

Spin time is the duration that the basket will spin after the cook cycle. The basket will not spin
after a cook cycle if the set spin time is set to 0.
 Display shows [nST mm:ss] [TIME] where "n" is the key number, ST means Spin Time, and
"mm:ss" is minutes and seconds.
 Use the product keys for numeric entry to adjust the current setting. Press the
to save spin time.
2.2.6

Spin Rate

Spin rate is the maximum speed the basket will spin after the cook cycle. The spin rate value
must be between 200 and 500.
 Display shows [nSR XXX] [TIME] where "n" is the key number, SR means Spin Rate, and
"XXX" is the rate in RPMs.
 Use the product keys for numeric entry to adjust the current setting. Press the
to save spin rate.
Display will again return to
2.2.2 to make changes to any other product keys or continue.
2.3

To Exit Level 1 programming:

Display shows
Press the key. Display shows
Options", or, exit here in the next step.
To exit Level 1 programming, press the
Displays will show
are running.
.
. Continue to section 3 "To Change
key again.
; , or
Page 9 of 28
Spin Fryer I12 Cooking Computer
Pitco P/N 60149505
. Repeat steps from section
, when no active cooks
L22-355 Rev 1
key
key
key