Pioneer RM-V2550 Manual page 95

<Assigning IDs from a computer>
Command: IDC (ID Clear)
IDS (ID Set)
The IDS command is only valid when no ID is assigned, and is value from the unit closest to the
computer (remote control unit).
Example: With a 4-screen system (when assigning ID numbers for the first time from a computer)
Multii projection
Computer
unit
**AJY
01IDS
**AJY
02IDS
**AJY
03IDS
**AJY
04IDS
ID numbers can be assigned to all the units by sending commands in this order. However, the ABL linking
cables must also be connected as shown above.
The characters that can be used for ID numbers are numbers 0 to 9, letters A to F (not case sensitive) and *.
The * (asterisk) can be used as follows:
**IDC : Clears all the ID numbers assigned to the units.
*0AJY : Sets the adjustment mode only for units with "0" as the second digit.
3*IN1 : Sets the input function to VIDEO only for units with "3" as the first digit.
Clear assigned ID
Assign ID
Multii projection
unit
ID=01
Multii projection
unit
ID=02
ADJUSTMENTS
Multii projection
unit
ID=03 ID=04
85