Table of Contents
Advertisement
(5) Tint adjustment [TNT command]
Input :
TNTd
d
d
1
2
3
Explanation: Corrects the tint of the NTSC input board.
d
d
d
1
2
3
TNT?
TNT
• To execute this command, it is necessary to set the adjustment mode by AJYC. (Refer to the
AJYC command.)
• If data input is skipped, the sub command input mode is set after the data is displayed.
The sub command mode is the same as with the COL command.
• The changed value is memorized the last.
(Example) TNT
6. Controls the panel switch function
(1) To set the manual mode [MNL command]
(2) To set the remote mode [RMT command]
Input :
MNL
, RMT
Explanation : • Manual mode
• Remote mode
(3) To select composite video input [CIC command]
Input :
CIC
Explanation : • Select the composite video input of NTSC input board.
• This command is executed in the remote mode.
It is ignored in the manual mode. (Refer to the RMT command.)
(4) To select YC separation input [YIC command]
Input :
YIC
Explanation : • Selects the Y/C separation input of the NTSC input board.
• This command is executed in the remote mode.
It is ignored in the manual mode. (Refer to the RMT command.)
: Compensation value 0 to 255
: Help display
: Displays the current value and moves to the sub command mode
Indicates the current tint value.
128
: Makes the following switch functions effective.
1 Variable scan board filter on/off switch
2 VBS/ Y/C select switch
3 MODE switch (The RESET button is required.)
The manual mode is set at POWER ON (or RESET button).
: Mode in which the above switching setting are selected via the RS-232C line.
In this case, the above switch states are ignored.
The settings which can be switched by the remote mode are as follows.
• Optional RGB board FILTER ON/OFF switching
Refer to the DSY and DSN commands (RMD-V3020)
• V IN (Composite video/YC separate) switching
Refer to the CIC and YIC commands.
• V OUT output format (MODE) switching
Refer to NT, NTR, NTD commands.
MVP MANUAL
167
Advertisement
Table of Contents
