Pioneer RM-V2550 Manual page 57

[9] Attach the screen frame support brackets onto the bottoms of the cabinets using screws. [Fig. 3-4-10]
Screen frame support brackets
Screws (4 dia. x 16)
NOTE) To prevent hazard, never mount on a cabinet.
[10] Block the holes on the cabinets (on the surfaces that become the outer panels of the system) using light
insulating stickers. [Fig. 3-4-11]
Light insulating stickers
Light insulating sticker
7 Procedure when the system is installed up against the rear wall
[11] When the system is to be installed up against the rear wall, perform the procedure till step [10] above while
the system is apart from the rear wall, then complete the rear wiring.
[12] Check the operations including those of the power supply.
[13] After ensuring that there is no problem in operation, release the adjusters of the stands temporarily and
approach the entire system to the wall by moving it slowly and cautiously.
[14] After moving the system to the installation location, secure the adjusters of the stands.
x 10 (provided with cabinets)
Side of cabinet
(Side panel) 2 holes per surface
x 4 (provided with screen frames)
x 8 (provided with screen frames)
Holes to be used (x 2 on left and right)
Screen frame support brackets
[Fig. 3-4-10]
(Top panel) 1 hole per surface
[Fig. 3-4-11]
INSTALLATION AND ASSEMBLY
47