White Balance Adjustment Flowchart - Pioneer RM-V2550 Manual

ADJUSTMENTS

(4) White balance adjustment flowchart

When adjusting the multi projection unit Initial setting
1 White balance adjustment (COMBI OFF)
2 ABL link and LINEAR WHITE flesh color adjustment (COMBI ON)
ABL LEVEL adjustment (White 100%)
ABL GAIN adjustment (White 100%)
(Note)
After completing adjustments, if the lumi-
nance of the multi-screen has dropped, or
the luminance is not consistent, change
the setting of the ABL switch and repeat
from step 2 .
110
Multi on
ABL switching setting (Refer to page 111 (5) White balance adjustment)
START
Black level adjustment (white 10%)
HIGH LIGHT adjustment (white 50%)
LOW LIGHT adjustment (white 20%)
NG
HIGH, LOW LIGHT check (white 0% to 100%)
OK
ABL GAIN adjustment (White 100%) (Fix to maximum normally)
ABL LEVEL adjustment (White 100%)
LINEAR WHITE adjustment (Cross hatch) (Fix to maximum normally)
HIGH, LOW Light check (white 0% to 100%)
OK
ABL check (white 0% to 100%)
COLOR ,TINT
Is INPUT
NO
Function
SHRPNESS check
RGB?
YES
COLOR adjustment
TINT adjustment
SHARPNESS adjustment
Rough adjustment end
Moving image adjustment
Moving image check
NG
Re-LINEAR WHITE adjustment (Cross hatch)
Re-HIGH LIGHT adjustment (White 80%, 50%)
Re-LOW LIGHT adjustment (White 20%)
HIGH, LOW LIGHT check (White 0% to 100%)
OK
NG
NG
OK
End
When W/B is incorrect
Fine adjustment input