To Set The Output To The Ntsc Mode [Nt Command]; To Set The Output To Standard Rgb Mode [Ntr Command]; To Set The Output To The Double-Speed Rgb Mode [Ntd Command]; Optional Variable Scan Board Adjustment Mode Settings [:A Command] - Pioneer RM-V2550 Manual

MVP MANUAL

(5) To set the output to the NTSC mode [NT command]

(6) To set the output to standard RGB mode [NTR command]

(7) To set the output to the double-speed RGB mode [NTD command]

Input : NT , NTR
Explanation : • NT : Sets the NTSC input mode.
H : 15.734 kHz
V : 59.94 Hz
Composite video, Y/C output
• NTR : Sets the standard speed RGB mode.
H : 15.734 kHz
V : 59.94 Hz
• NTD : Sets the double-speed RGB mode.
H : 31.469 kHz
V : 59.94 Hz
• This command is executed in the remote mode.
It is ignored in the manual mode. (Refer to the RMT command.)
(NOTE)
With the RMD-V2550BU, only standard speed input is possible.

(8) Optional variable scan board adjustment mode settings [:A command]

Input : : A
Explanation: • Used when adjusting the optional variable scan board (RMD-V3020).
• To exit the adjustment mode, omit the parameters and input :
• For details on adjustments, refer to "VS Board Command Reference" on the following pages.
168
, NTD
.