Assembling The Mounting Hardware And Mounting The Plasma Display - Pioneer PDP-502MX Manual

4.7.3 Assembling the mounting hardware and mounting the plasma display

1) Precautions before assembling
• Make sure you distinguish correctly between the vertical frames for right and left.
Both should be mounted so that their hexagonal sockets face outward.
• The horizontal frames should be mounted so that their smaller openings face the wall.
A total of eight openings are provided in the horizontal frames for wall-mounting. (A total of fourteen openings are
provided in the PDK-5006 itself.)
2) Assembly procedure
1 Loosen screw a and separate one end of the hook from the screw.
2 Hold the upper part of the vertical frame and open to an approximate width of 10 cm.
3 Mount the horizontal frame to the vertical frames.
Vertical frame (right)
Hexagonal
socket head
flange bolt
Hexagonal
socket head
flange bolt
Tiltable Plasma Display Wall-Mount Hardware: PDK-5006
a
Loosen the screw until you can no longer
see its end through this opening.
Vertical frame (left)
Horizontal frame
Hexagonal sockets
facing outward.
This side should face the wall.
(The smaller holes should
face the wall.)
a
Hexagonal socket head
flange bolt
The surface should
face the wall.
Hexagonal socket head
flange bolt
Horizontal frame
Positioning the screw with a fingertip,
tighten the screw with a hexagonal
wrench.
Hexagonal
wrench
67